Jump to content

Little 2 part screw that holds the trigger group in on an m1014


kharnifex

Recommended Posts

hi,

 

so a few years ago i stuck a sidesaddle on my m1014, strangely enough the side saddle replaced the trigger group pin on the receiver with a longer one. Fast forward those few years and i've taken off the side saddle only to realize i lost the original pin. bought a new one from brownells i think, but it's different. it's one piece and sticks out slightly from the receiver all ghetto lookin.

 

my question to you is if anyone knows where i can find the original 2-piece allen wrench screw, or if someone knows of a good replacement for it.

 

Thanks!

Link to comment
Share on other sites

I contacted benelliusa, they told me to go through midwayusa who couldn't get it, and brownells, which sent me the one piece screw with retainer ring.

 

looking at my manual, you're right, its called an axle bushing.

 

according to a parts list it says a retaining ring, spacer and spring plus axle bush go in that hole. i have the feeling i'm missing the spacer and spring meaning my bushing sticks out too far on the breech side.

 

i have the axle bushing sitting too deep in the hole with the retainer ring holding it in on the outside of the hole. I'm pretty sure i need the spacer and spring. then i can reassemble the axle correctly.

 

i realize now, that the two piece screw was the retarded side saddle one. and i'm just missing the spacer and spring.

 

any info on what to ask brownells for would be greatly appreciated. i've never had good luck finding stuff on their site.

 

Thanks!!

Link to comment
Share on other sites

ben-M4.gif

 

You need parts #51, 52, 53, 54

 

51 -- Retaining Spring

http://www.brownells.com/.aspx/sid=50291/pid=0/sku/Retaining_Spring

 

52 -- Retaining Spacer

http://www.brownells.com/.aspx/sid=51009/pid=0/sku/Retaining_Spacer

 

53 -- Retaining Ring (Snap Ring)

http://www.brownells.com/.aspx/sid=50341/pid=0/sku/Retaining_Ring

 

54 -- Axle Bushing (Trigger group pin itself)

http://www.brownells.com/.aspx/sid=50288/pid=0/sku/Axle_Bushing

 

So you need part #51 and #52.

 

Do you have the snap ring to reassemble everything with?

 

Hope this helps.

Link to comment
Share on other sites

Awesome! this is exactly what i needed. Thank you Stranger. seeing my m1014 not at 100% always makes me sad. I'm glad i now have the knowledge needed to get her back to spec.

 

Thanks again!

That is what they pay him for (I hope someone is paying StrangerDanger) a good site to reference is benelli.it the Italian website. There is an American flag in the top left corner that will translate it to English (do not use a browser translater it just gums stuff up) it has all the manuals, diagrams and hot nakid Italian chicks modeling the guns.

regards,

-d

Edited by d
i not perfect
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...