Jump to content

Hi-Viz removal|installation


crofton

Recommended Posts

Borrowed my neighbors heating iron and in 5 minutes factory magazine tube removed. Installed carriercomp Fl and now attempting to remove the Hi-Viz with the complimentary tool provided.

 

Noting the following two pictures:

 

1. the funneled end is too small for the fingers of the Hi-Viz.

 

2. the tool also is shorter than the factory follower.

 

How does one use the cylindrical tool?

 

http://003-2.jpg

 

http://002-1.jpg

 

 

 

 

Edit: Guess this is the solution, in any event it worked.

 

Just found out that only two images are allowed. :-( Check the following post.

Edited by crofton
Found solution
Link to comment
Share on other sites

Solution, at least it worked for me. Inserted one tip of the needle nose pliers into the non funneled end of the tool. Covered the fingers with the tool (it does fit) and pushed the Hi-Viz flush with the follower. Using a punch, pushed the Hi-Viz out of the follower.

 

http://001-1.jpg

 

And here it is:

 

http://004.jpg

Edited by crofton
Typo
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...