Leaderboard

Update: A&S trigger guard ordered ? Thanks for helping me “pull the trigger” on that ??

The pictures helped a lot. The hammer is hanging up on the disconnector. When the trigger is let go, the hammer hook should come off the disconnector and engage the trigger hook. So either; 1. The hammer is out of spec (possible but unlikely) 2. The Disconnector is out of spec (Unlikely) 3. The trigger is out of spec. Or, it is possible that the trigger spring is not installed correctly. I would install the factory hammer and see if the issue still exists. If the problem is still present, pull the trigger pack out and verrify that the spring is seated correctly and functioning. The spring should be returning the trigger to its forward position. If you can manually pull the trigger forward, there is something wrong. Listen to hear if the disconnector is disengaging and allowing you to pull the trigger normally. If the spring seems fine, swap to the stock disconnector on the FFT trigger and try again. If the problem still exists, swap back to the stock trigger. The goal is to determine which part is causing the problem.