Jump to content

Derrick

Members
  • Posts

    10
  • Joined

  • Last visited

Posts posted by Derrick

  1. On 1/17/2019 at 10:03 AM, Steve Rose said:

    The pin only comes out from one direction. You drive out the pin by inserting a flat tip punch into the hole opening that only allows you to see a portion on the pin's diameter-in other words your punch will contact about ½ of the edge of the pin's end

    That sounds tricky. I was helping a buddy installing the brake kit and xd wheels on his truck when he mentioned he's having hard time removing the extractor. We'll check it out this weekend.

  2. On 1/27/2019 at 5:16 AM, Evolution said:

    No worries....it's not uncommon at all to have to do minor fitting with stocks even OEM. They are after all, a moulded item and not CNC machined. Yes, either a blade or even more controlled, is sandpaper wrapped around a small wood block or similar and go slowly remove a little bit of material at a time from the part that curves around the back of the trigger housing following it's curves. Check frequently until the trigger housing will seat fully into the receiver and the pin will latch through without using excessive force.

    That explains how to do the trick.

×
×
  • Create New...