darkjedi351 Posted June 12, 2009 Share Posted June 12, 2009 anybody using or used one of these? how the fit and finish? are the rails all jacked up and out of spec? any other options out there? i'm looking at one for my m2 mainly for the side saddle but any input is appreciated. thanks Quote Link to comment Share on other sites More sharing options...
Creeper Posted June 13, 2009 Share Posted June 13, 2009 The latest (revised screws and countersinks in the 1913 rail... as of around February of this year) version fits just fine. I have the 6 shell model on my M2... no problems in around 2500 rds. Contact Mitch at MT for all the revision info. C Quote Link to comment Share on other sites More sharing options...
darkjedi351 Posted June 13, 2009 Author Share Posted June 13, 2009 Thanks creeper. i don't plan on putting a sight on it but i've read (here) that mounts can pop off of the rails like on the m4. have you had any problems? thanks Quote Link to comment Share on other sites More sharing options...
AndyUK Posted June 13, 2009 Share Posted June 13, 2009 I have a 6 shot version on a SuperNova holding an EoTech 512.A65 absolutely no problems after 2000+ shells BUT I did have the receiver drilled and tapped by a gunsmith as it did not come pre-drilled/tapped. Rgds Andy Quote Link to comment Share on other sites More sharing options...
Creeper Posted June 13, 2009 Share Posted June 13, 2009 (edited) Thanks creeper. i don't plan on putting a sight on it but i've read (here) that mounts can pop off of the rails like on the m4. have you had any problems? thanks I'd imagine much of what you read was prior to 2009. I also suspect the many of the failures were due to over-tightening the rail screws and/or not using Loctite. They admittedly did have some issues with the screws/countersinks they used at the time... which certainly contributed to problems, but since they've switched to Benelli type screws, cool conical washers and matching countersinks, I imagine you'll be seeing far fewer complaints. A 1/4" drive in.lb. torque wrench is always a good invesment when you like to tinker with guns. C Edited June 14, 2009 by Creeper Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.