Jump to content

Benelli Ultra Light ButtPlate Removal/Shim Adjustments


Wade1998

Recommended Posts

Hello all,

 

Just purchased a Benelli UltraLight 12 Gauge, great gun, but the drop is a bit off for me.

 

I have read in the manual, how to replace the factory shims, however the rubber butt plate has no screw hole openings (I am an old Remington Owner). The manual recommends using a Philllips (Cross-Point) Screwdriver and to use vaseline or no chemical lubricant to remove the screws from the buttplate.

 

Since there are no holes, and rather than take a guess and puncture several holes in the rubber buttplate/recoil pad does anyone have advices on how to remove this cleanly?

 

I need to drop the adjustment a little and would like to replace the installed 'B' shim with the 'C' Shim.

 

Any suggestions would be greatly appreciated.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...