Jump to content

MR1 Assembly problem


BobJohnson

Recommended Posts

Hello All,

 

I'm having a problem assembling my MR1. I'm at step 6 of the assembly instructions: "Lodge the end part of the cover into the receiver and push all the way in until the whole unit clicks into place at stroke-end, and fits snugly. Warning: as the bolt link passes over the trigger guard it must fit itself into the recoil spring tube inside the receiver".

 

I am unable to get it to fit snugly. I've tried many times very carefully. Please see the attached image. That is as close as I can get it to fit. If anyone has run into this problem before or has some suggestions I would very much appreciate some advice. Thanks a lot!

 

  1. [ATTACH=CONFIG]1213[/ATTACH]

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...