Jump to content

Freedom Fighter Full length Magazine Tube install


kimurabean

Recommended Posts

That comes with the correct length spring, so you're good to go with that kit, ( aside from needing a heat gun. )

 

I ordered the same thing for mine, but decided to replace the follower with one from FFT, too.

 

So I assume using a heat gun is to seal the tube into place or remove the old tube?

Link to comment
Share on other sites

The heat gun breaks the threadlocker where the original mag tube is screwed into the receiver.

 

There is a lot of variability in how long you have to heat it up to get it to break loose. The carriercomp instructions didn't work for me at all; I had to heat the receiver much hotter than they instructed. Some break loose without too much effort. Mine was a b*tch.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...