Jump to content

I need help with Benelli M4 buffer tube installation please


Aymon

Recommended Posts

Hello,

I was removing the civilian 1 position buffer tube of my Benelli M4 to replace it with an MIL Spec buffer tube. 

But I forgot how deep I need to screw the new buffer tube in.

If you can tell me or show me how far the buffer tube needs to be screwed it, I would be very thankful.image0.jpg

Link to comment
Share on other sites

You want 8.5 full rotation from the point the threads grab. Then time it so that the collapsible stock is indexed correctly. I collapse the stock onto the receiver extension and use the pointy part of the cheek rest to point at the center of the rear sight. I then tighten the jam nut with the open end of the 27mm wrench. Then remove the stock, slip the close end of the 27mm wrench over the end and firmly tighten it while putting counter pressure on the extension with a 19mm wrench on the flats of the extension. Verify that the extension didn’t move with the stock again after tightening.

  • Like 1
  • Upvote 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...