Mudboy Posted August 15, 2004 Share Posted August 15, 2004 I just purchased my first Benelli, an M1 Super90 Military/Police and I would like to replace the PG stock with a standard stock. How does the the butt pad come off, or how do I remove the PG stock? Quote Link to comment Share on other sites More sharing options...
M1014 Posted August 15, 2004 Share Posted August 15, 2004 welcome Mudboy,two phillips heads screws in the rubber buttplate need to be unscrewed ,remove the rubbber buttplate ,then theres a shaft that at the other end is a 13mm bolt that you unbolt and carefully remove the stock,refer to your owners manual its real easy.>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>M1014 Quote Link to comment Share on other sites More sharing options...
Mudboy Posted August 15, 2004 Author Share Posted August 15, 2004 Thanks for the prompt reply and the welcome. I don't have the manual (yet); the SG came lightly used with one spare choke and the choke wrench. I need to call Benelli on Monday to get a manual and to check the serial number for date of importation. As far as removing the buttpad, there are two very small holes in the pad under which I will assume the screws lie. Since I won't be able to see them, how about some insight as to what size of philips driver? Finally, am I correct in assuming that Benelli is the only source for the standard buttstock? Quote Link to comment Share on other sites More sharing options...
djansma Posted August 15, 2004 Share Posted August 15, 2004 # 2 phillips and put some type of oil on the screwdriver so it does not harm the rubber as yo are turning thr screws out silcone spray David Quote Link to comment Share on other sites More sharing options...
M1014 Posted August 15, 2004 Share Posted August 15, 2004 thanks dajansma for the backup ================M1014 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.