Jump to content

Montefeltro Magazine Disassembly


slevar

Recommended Posts

Caution!!! The mag tube is threaded into the receiver with loctite. The only way to access the mag tube is to unscrew it from the receiver. OK, be careful in doing this and if in doubt, dont do it. Remove the trigger assy, bbl, and forend. Put the mag tube in a padded vise (not too tight in fear of crimping it but tight enough to hold it well). Use a heat gun or a very hot hair dryer not a torch of any kind at all to heat the area where the mag tube screws in. Heating this area will loosen the loctite, mind it will have to be very hot. It will not harm the finish as long as a flame is not used. Using a proper fitting hammer handle or other device, insert it into the receiver near the entrance to the magtube to turn it off. They are coarse threads and they are right hand. Clean it and then when reinstalling the magtube use at least a blue loctite to hold it on. This must be done because the barrel headspaces off the magtube and if it comes unscrewed the barrel will move foreward out of battery. Hope this helps.

Link to comment
Share on other sites

  • 4 years later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...