CoolhandLuke Posted February 21, 2007 Share Posted February 21, 2007 I have a Benelli Super Black Eagle II and I just bought it and it hits about 6" to the right. What shim do I need and how do you put it in? Quote Link to comment Share on other sites More sharing options...
tucker301 Posted February 22, 2007 Share Posted February 22, 2007 Righthanders use DX. Lefthanders use SX. That's the only cast adjustment there is. Quote Link to comment Share on other sites More sharing options...
CoolhandLuke Posted February 22, 2007 Author Share Posted February 22, 2007 Why wasn't this part included with my gun? Isn't that part the cast adjustment? Well I was going to post a pic but for some reason...I can't. It is the part in the lower right corner that says SX http://www.benelliusa.com/firearms/large/partsShims.jpg Quote Link to comment Share on other sites More sharing options...
tucker301 Posted February 22, 2007 Share Posted February 22, 2007 Yes, it's called cast. RH guns are typically "cast off" and LH guns are setup "cast on". In either case, the stock is angled slightly away from the cheek to allow the shooter to get squarely behind the gun. The steel plates with the off-center holes determine the cast. As HW stated, the manual outlines how to arrange them for the desired cast and drop. If you don't have all the pieces, contact Benelli and ask for them Quote Link to comment Share on other sites More sharing options...
dagrizz Posted February 22, 2007 Share Posted February 22, 2007 Why wasn't this part included with my gun? Isn't that part the cast adjustment? Well I was going to post a pic but for some reason...I can't. It is the part in the lower right corner that says SX http://www.benelliusa.com/firearms/large/partsShims.jpg If you take the recoil pad off you will see this part inside the but stock. If it is like my M2 all you should need to do is to remove the one that is in there pull it straight out and look at it. Then turn it over and re insert it. Mike Quote Link to comment Share on other sites More sharing options...
buck_uncle Posted February 23, 2007 Share Posted February 23, 2007 what you need to do is add more cast off unfortunetly the cast shim is either cast on or off, and u can't vary it. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.