HalG
-
Posts
6 -
Joined
-
Last visited
Posts posted by HalG
-
-
I may get roasted for this but here goes. I made a clone of the Noveske bracket for my second M4.
3/16" x 5/8" x 4.5" aluminum bar
Benelli screw holes 13/64th dia and 3-15/16" on center. 90deg countersink leaving 1/16" not c-sunk.
Limbsaver holes are 10 x 32pitch and are on 3-5/16" centers.
Ends are shaped leaving 5/16" flat centered. Measure down the sides and remove the outer edges to the line. Narrow end 1/2". Rounded end 1/8".
-
I've always used EEZOX on mine. I like this product a lot and use it on all but my antiques.
-
Gracias.
Hal
-
Does anyone know the max/min LOP of the collapsible stock? Can someone measure theirs for me and post the info?
THNX
-
Does anyone know where I can get a better recoil pad for my M4?
Benelli M4 -- Rear Sling Plate Removal
in Benelli
Posted
Ran across this as I was looking to change out my rear sling attachments. Good stuff. I made a small mod that might interest you guys. One of my M4's was a real PIA to get apart. The pin was short threaded and the retainer plate was force threaded down. I wound up having to red locktite a nut on the other end to get enough grip to break it loose. Anyway I came up with this idea so I wouldn't have to mess with a recessed nut on the opposite end. I put a slot in the end so it can be tightened up with a screwdriver during a reinstall. I was able to get a good tight fit with a screwdriver. If I reassemble with blue locktite the plate (278J) can simply be unscrewed after the locking nut is removed.
My setup. A bit of paper towel to hold the pin for insertion into the stock. The screw slot from above.