[AR Style Safety - Like or No Like?]

I use mostly 45 degree FIRE selectors on the AR platforms. I don't are for the ambidextrous part of this unit. I'd be happy with just a strong hand thumb side lever. My hope would be the lever having the same tactile feel of the AR15 selectors to provide a cross platform standard of use.

I agree this would be a good idea. I shoot a lot of AR platform style guns and think this type of safety would feel automatic.

[Benelli M4 in John Wick 2]

I want to see it, but I want even more not to go to a movie theater.

 

I agree 100%. Have not been to the movie theater in more than 15 yrs.

[Any recommended gunsmiths for Benelli M4 mods in Phoenix AZ area?]

I heated mine with my wife's hair dryer.

 

Got the receiver up to about 180 degrees and the magazine started turning by hand.

 

Had to apply heat a few times to keep it up around that temp or it would get tight.

 

Seems like there are a million threads there when you start trying to screw it off.

 

I would rather heat the receiver than the mag tube.

 

I also used wife's hair dryer. Took about 4 or 5 min. and unscrewed with just a little bit of muscle. It had blue Loctite.

[M4: Stippling Hand Guards?]

Hi,

Trying to figure out a pattern, not sure if I want to do the whole grip or if it's necessary. Good tip about the Dremel, thanx!

 

How long did it take?

About 45 min.

[M4: Stippling Hand Guards?]

I did my M4 like this one with a $5 iron from Harbor freight. I had to buff the high points after I was done because it was cutting into my hand. I used a Dremel with a wire wheel. Not only does it look good, but function is great.

[Briley bolt release DIY install mods for Benelli]

That is exactly how I did mine. I also sprayed the outside surface of the button with truck bed liner which makes it non slip and stealth look.

[M4 and low recoil ammo]

My M4 will eat anything you can put in it, but when it was new it ran a little sluggish with light loads. This was because it was dry. After putting some oil to the internals it ran like a scared rabbit.

[benelli collapsible stock]

Before you sell try Ace Hardware, they have a large selection of these type of screws.

[Which optic should i use on my M4? OPINIONS.]

I would have to agree with strangerdanger 100%. A good low profile and able to co witness the iron sights works out great.

[Factory Benelli tube or CarrierComp?]

I went with DMW(daves metal works) ordered on Mon. received it on Wed. Color matched, fit perfectly, came with new spring, and works great. I do not know what the fascination is with waiting 3 plus months for CC.

[Cannot remove OEM mag tube]

Mine came off with a hair dryer. So it's just how much lock tite they use.

[Best place / price on M4]

Scored M4 from gunbroker for 1500 shipped. It was a used gun that was never used. I got to tell you that is the sweetest shotgun I have ever shot.