[How to Install part 60004 SBE 2 Extended Bolt Catch Release]

SOLVED!

 

from Benelli:

The paddle should just unscrew from the latch. If they put a little Loctite on it it's probably just blue so a hair dryer for a minute should loosen it.

It was on there pretty good.  Just unscrews for installation and screws back on  

 

 

 

[How to Install part 60004 SBE 2 Extended Bolt Catch Release]

I’m sure someone on here has installed this same part.  

[How to Install part 60004 SBE 2 Extended Bolt Catch Release]

Yes I search YouTube. That is why I’m posting here.  

I appreciate your post, but I need instructions specific to this performance shop part  it is a Benelli part and no aftermarket  

I know how to take off the catch release and install. That is no the issue. 

 

60004 has the button already installed. It replaces the stock button and bolt catch. 

My question is specific to this part. I am not installing just the button (drilling and tapping stock button)

 

i need to know if the button unscrews. I’ve tried, but I do not want to vent the actual release. 

 

Thanks

[How to Install part 60004 SBE 2 Extended Bolt Catch Release]

Hi all. After waiting a few moths, I was finally able to find a Performance Shop  Extended Bolt Release for my SBE 2. It is part number Benelli part number 60004. 

It came with no instruction. However, I did know how to remove the stock bolt release from the receiver and have done so. 

The problem now is the the the button on the Performance Shop bolt release is to large to fit in the receiver hole. 

Has anyone installed this part before?  Does the button unscrew from the assembly for installation?

Any help would be appreciated.!