[email protected]

Mod worked great! Course I was just trying it to see if I could do it ... MR1 + same Benelli Supernova Tactical Collapsible Stock bought off Amazon. At first I was gambling because I hadn't looked at the stock shaft (Recoil spring tube 049V)to tell if it had the notches in it, but it did. Had to pull of the rubber butt plate, then ratchet out the Stock retaining screw (053V). At this point it seemed obvious the Nut (075S) had to slide over the Recoil spring tube, but mine actually wouldn't. It got stuck 1/4 way down. Then I got a recommendation to use some sand paper and wraped a small peice around my finger, slid it inside the nut to file down the threads just a small touch. This worked perfect and the nut slid all the way to the base. Last part was trying to get the trigger casing to fit. Comparing the old stock with the new collapsible stock, you can tell there is a small difference. I didn't have a dremel, so I used an exacto blade and a couple of files to get the shape pretty close. Just getting it part wasy seated is good, since when you tighten the nut down, it will seat the rest of the way since it's plastic. Been hunting for this stock, and last x-mas only found words that it had to be bought in CA, or Italy. I seriously would have taken the trip to get it. Now that I have it, in combination with the Eotech magnifier, I am able to dial in perfect eye relief. Sadly, I was going to return the Eotech or resell it, but now it's completely usable. Thanks for the inspiration to MOD!!!