Jump to content

accuracy

Members
  • Posts

    2
  • Joined

  • Last visited

Everything posted by accuracy

  1. The springs I ordered didn't help. Guess i will drop the $50 on a new latch and see what I come up with, thanks for the advice.
  2. Hi, I'm reposting a question I also posted on shotgunworld. I noticed that after ghost loaded a shell onto the carrier of my M1 (with or without shells in magazine). Then tried to rack the bolt to load the ghost round by hand, the bolt would often hang up on the back , unable to lift the shell up and chamber the round. However, as soon as I either applied a little forward pressure on bolt, lift up on carrier, or press magazine latch. it will easily chamber the round. Round doesn't have to be ghost loaded to do this, as If i release a shell from magazine via lever, and try to rack the bolt, it does the same thing. I completely stripped and cleaned trigger group, cleaned/reoiled recoil spring, cleaned and reoiled bolt and inside receiver. Now it is a lot better, but will still want to hang up trying to load the shell on the lifter with nothing in the magazine tube. If there are rounds in the magazine, then it seems to load normally. I read that this issue could sometimes stem from a worn magazine latch spring (have one on the way). However Looking inside the receiver I noticed that it has a lot of wear, opposite side to magazine latch. it is slightly gouged/galled. It kind of looks like the rim of the shell is hanging up on the gouge in the receiver. Is there a reason why my gun has so much wear here or just normal for high round count benelli's. Mods: Nordic +5 ext and spring. TTI Reduced power recoil spring (I haven't fired the gun in several months however, last time I went out i went through about 100 rounds (hi brass, 00buck, light game loads) no malfunctions, and didn't notice shells hanging up). I ordered the following: Mag latch spring Carrier spring. Any one else have wear marks like mine? Or perhaps My nordic magazine spring is too long/powerful and causing shells to be sent onto my lifter too hard, then gouging the receiver. I will note that I am not original owner of gun, and when I got it , i had non-stop FTE issues with any/all loads. Replaced pistol grip with conventional stock, and put in the reduced power spring, and began to cycle everything. Thanks all.
×
×
  • Create New...