Hi folks, I'm a new member to the forum. I was hoping to fine some advice about replacing the ejector plate. My SBE is the early H&K SBE (25 yrs old) low vent rib. Well it wasn't ejecting any mt's at all. On closer inspection I found the extractor was bad, so replaced it and the spring. Test fired didnt help. Then upon investigation, I realize the ejector plate was completely broken as in missing. Parts will be here Monday. New ejector plate, spring and set screws. My question is I know you heat and remove the two set screws, but for the life of me I can't remember how the ejector plate look or faced. Does it only fit one way or not? I cant seem to find any pictures or videos on the net at all. Any help, pictures, guidance or suggestions would be greatly appreciated. Also figured since I was replacing springs and such, I have a new recoil spri g on the way too. After reading post on other forums I figured I doing pretty good as this is the first time I've done anything to the gun other than keeping it clean. 25 yrs of duck and goose hunting with heavy loads, laid on the bottom of Lake Erie twice(in the shallows, terrible sling replaced) I'm thinking it's not doing too bad. Thanks in advance for your help and time.