misslebait

So looking at my box and the paperwork inside my gun, all the paperwork I have shows that this gun is a 3 1/2, but looking at the serial number compared to the serial number on the box. They are different. I just contacted the dealer and he has a 3 1/2 inch in a 3 inch box there. Thank you for all your insight. I need to pay more attention I guess to what I’m buying but all the paperwork I have indicated that this gun was a 3 1/2.

I am not sure. Where can I find that info

As i stated in the first post tried 3 different brands of 3.5 same result for all. this is a brand new gun fired 5 rounds total 1 3.5 and the rest 3"

correct

Here is some pictures..this is not a barrel issue this is a feeding issue. Ammo selection does not matter 3" cycle fine.

Bought a new sbe3 to replace an aging sbe1, purchased 1/19 went out yesterday loaded a federal blackcloud 3.5 first one dropped in the chamber, 2 in the magazine pulled up fired and had a failure to extract. round coming out of the magazine was stuck partially in the magazine and wedged in between the trigger group. disassembled gun cleared it and figured, fluke. Went to cycle and round coming out of the magazine get wedged between the magazine and trigger group. took a pocket knife and pushed back of the round up and it came free in the rear but front sill stuck partially in the magazine. So I changed shells thinking might be a overly long shell, Kent 3.5 tungsten, same issue, Switched to Winchester 3.5 same issue. At this point I am wondering WTF. Changed back to my SBE1 cycled and shot all this ammo without an issue. I am at a loss here is looks like the space between the magazine and trigger group is not allowing the round to fully exit the mag and get picked up by the feed ramp. I can duplicate and take pics if necessary