crofton Posted July 28, 2011 Share Posted July 28, 2011 (edited) Borrowed my neighbors heating iron and in 5 minutes factory magazine tube removed. Installed carriercomp Fl and now attempting to remove the Hi-Viz with the complimentary tool provided. Noting the following two pictures: 1. the funneled end is too small for the fingers of the Hi-Viz. 2. the tool also is shorter than the factory follower. How does one use the cylindrical tool? http:// http:// Edit: Guess this is the solution, in any event it worked. Just found out that only two images are allowed. :-( Check the following post. Edited July 28, 2011 by crofton Found solution Quote Link to comment Share on other sites More sharing options...
crofton Posted July 28, 2011 Author Share Posted July 28, 2011 (edited) Solution, at least it worked for me. Inserted one tip of the needle nose pliers into the non funneled end of the tool. Covered the fingers with the tool (it does fit) and pushed the Hi-Viz flush with the follower. Using a punch, pushed the Hi-Viz out of the follower. http:// And here it is: http:// Edited July 28, 2011 by crofton Typo Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.