tateb24 Posted April 30, 2013 Share Posted April 30, 2013 I just purchased a M1 straight stock for my m1 tactical. When I went to put it together I noticed a little bit of an edge where the stock and the receiver met. Its not noticeable except to me. Is there a shim kit that I need to buy to have these match these up?, I couldn't find anything in the M1 manual. I think I am nit picking, but I just don't want to install this wrong and then ruin a perfectly good stock. I have the installed the sling plate, lock washer and 13mm hex nut, the stock has the support bushing in the stock. I noticed there was a hole in the receiver that a pin or something might fit in to secure it. I believe this a later model M1 Tactical serial number M482XXX, it came with a pistol grip stock, and of course the ghost ring sights. I would greatly appreciate any advice. Thanks Quote Link to comment Share on other sites More sharing options...
Ding126 Posted May 9, 2013 Share Posted May 9, 2013 Looking for a pistol grip or the recoil pad from an m1 S90 tactical. [email protected] Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.