frankgoss

Have 4 Benellis three shotguns with take down grey plastic got for $35.00 . Bought R1 30:06 then added 300 WM barrel &bolt, but saw in Italy a two barrel R1 Benelli rifle take down case, but cant find on internet. They have grey shotgun take downs only. Any one know where I can get two barrel R1 Benelli plastic hard case? PS have many Beretta o/u Blue cases and one semi auto, but molded dont fit right for travel.

Anyone have any help. Called 10 local dealers they just refer back to Benelli USA. DONE THAT 6 months ago. Emailed Italy who said call USA. Buck passing must an Italian way of life.

Help Have two Part 81131 Open sight package but missing set screw for front sight spring load red glow blade. Called Benelli USA no help just send wrong parts. Have two barrels 30.06 and .300 win mag but. front sights will not work since no set screws supplied. Red glow stays in 45° angle and cannot adjust like Owner Manual pic 81!

Anyone else have issues with Benelli #81131 open sight package. Called and emailed Benelli customer service as well as MWG and supply chain issue. They admit package is defective since missing several correct screws and Maryland does not have in stock the correct screws. They tried to help by sending pins that are to thick s/b. 1/16×5/8" long for rear sight blade and they sent ejector pins from shotguns. On the front sight, the dove tail red sight is spring loaded, but they keep sending either small allen head for windage adjustment , way to small or gas cylinder screws which are for mounting base to drilled and tapped barrel. See below pic . blade is flat since the windage screw was assemblied in Italy, but that is not the the was they shipped to USA! The drawing they have are not the same as in the R1 OWNERS manual and that has created additional confusion. If you had this issue on open sights, please reply!

Bronwells does not carry 1/16" × 5/8" only 1/2" or 3/4" one two short one two long. Packs of 36 or 48 roll pins $3.99 or $4.99 packs. I need one?

retaining pin 1/16 " dia 5/8" long. Anyone know where to get Benelli USA has supply clain issues in Maryland.

Received one of those high demand 81131 open sights packages. Base installation no problem. Front- issue is what screw holds red blade down. Benelli USA say same as gas cylinder. Sends 4 . Will not thread in when spring loaded red blade is compressed? Screw will have clicks like rear elevation. Rear pin that holds rear blade and spring for elevation is too fat . It was from an extractor pin. Mine broke off and stuck into base right hole. Simple punch will remove but pin is not heat treated and bent when attempting to be installed. Benelli USA does not have parts other than gas cylinder hex screws in stock. Supply chain issues. Anyone successfully install these open sights?

Just received 81131 open sights . Parts missing two base hex screws. Pin is an ejector pin to large diameter pin, looks like wrong pin for rear elevation sight. Front elevation screw call for same screw as hex mounting screws, but will not tread in front elevation blade. MWG is aware of missing part. Benelli USA donot have spare parts other than base/ gas cylinder hex screws. No instruction available! If you had trouble installing , let us know?