Brad 10 Posted January 23, 2012 Share Posted January 23, 2012 I took the tigger out for the first time on my SS to clean it up. Now it doesnt want to go back in. The trigger hits the shim between the stock and the reciever. Its soo close but i really dont want to force anything. Any help/tips are greatly appreciated. Thank You Quote Link to post Share on other sites
twowheelhooligan 10 Posted January 24, 2012 Share Posted January 24, 2012 Have you moved the bolt release out of the way? I slide in the rear of the trigger group up by the stock. Swing(rotate) the trigger group upward until the carrier contacts the bolt release. Then you need to press in on bolt release to get it out of the way for the carrier to fit inside receiver. (**NOT** Being a smart ass!!)) 1) breath! 2) slow down 3) look at how it all works. 4) as much as it pains us guys sometimes, read directions. Best of luck! 2-wheel Quote Link to post Share on other sites
Spike100 10 Posted January 26, 2012 Share Posted January 26, 2012 2-wheel, Great points… Benelli guns have a relatively simple break-down. The process is very intuitive, and the gun comes with great instructions. If it isn't initially obvious, I can usually figure it out through trial and error. --Spike Have you moved the bolt release out of the way? I slide in the rear of the trigger group up by the stock. Swing(rotate) the trigger group upward until the carrier contacts the bolt release. Then you need to press in on bolt release to get it out of the way for the carrier to fit inside receiver. (**NOT** Being a smart ass!!)) 1) breath! 2) slow down 3) look at how it all works. 4) as much as it pains us guys sometimes, read directions. Best of luck! 2-wheel Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.