922r replacement parts question

[brobin10]

i have purchased a usa made full length mag tube, usa made mag follower and a usa made foregrip.....i have a c-stock being delivered in the near future.

 

what is the next easiest part to replace to maintain 922r compliance? i was thinking the trigger but was worried about how to do it exactly....any guides/videos out there showing trigger replacement?

 

maybe there is another part that I am not thinking of that may be easier to swap

 

any advice welcome!

[KB Fab]

The US made hammer, either from Geisselle or FFT, would be the easiest part to add IMO. All you need is a pair of snap ring pliers and the part is a drop-in replacement. I've done it to one of mine and it's super easy. The Geisselle part is of superior quality. I have no experience with the one from FFT.

 

http://shop.carriercomp.com/product.sc?productId=15&categoryId=5

 

http://freedomfightertactical.com/products-page/922r-compliant-trigger-parts/the-freedom-fighter-tactical-922r-compliant-hammer/

[brobin10]

thank you very much for the information....would these pliers work?

 

http://www.amazon.com/TEKTON-3578-Universal-Snap-Pliers/dp/B000NPPAUC/ref=sr_1_1?s=power-hand-tools&ie=UTF8&qid=1343315458&sr=1-1

 

i think the geisselle trigger is very hard to come by right now....may just have to go with the FFT one...i have been eye balling that one

 

what about these pliers....do i need a certain size?

 

http://www.amazon.com/TEKTON-3571-7-Inch-Internal-Pliers/dp/B002RCAWKC/ref=sr_1_11?s=hi&ie=UTF8&qid=1343315579&sr=1-11&keywords=snap+ring+pliers

[heckler&kochp2000]

Yes they will work !

[brobin10]

thanks i will order them now...gotta love amazon prime!

[KB Fab]

Geissele recommends these particular pliers for the installation and I can tell you that they were spot on. Others may work but these are for sure.

Blackhawk model PT-1285 0.038

inch diameter tip, McMaster Carr PN 5415A11

 

 

Here's a link to the PDF installation instructions.

 

 

http://geissele.com/pdfs/m4binstructions.pdf

[brobin10]

thanks...i am looking for them now

[Alaskan Infidel]

Umm. the magazine follower is a little easier.

[Alaskan Infidel]

Sorry... missed it, never mind.

[rokuss]

i have purchased a usa made full length mag tube, usa made mag follower and a usa made foregrip.....i have a c-stock being delivered in the near future.

 

what is the next easiest part to replace to maintain 922r compliance? i was thinking the trigger but was worried about how to do it exactly....any guides/videos out there showing trigger replacement?

 

maybe there is another part that I am not thinking of that may be easier to swap

 

any advice welcome!

 

You need to add another US part when you install the collapsable stock!