Aymon Posted November 20, 2020 Share Posted November 20, 2020 Hello, I was removing the civilian 1 position buffer tube of my Benelli M4 to replace it with an MIL Spec buffer tube. But I forgot how deep I need to screw the new buffer tube in. If you can tell me or show me how far the buffer tube needs to be screwed it, I would be very thankful. Quote Link to comment Share on other sites More sharing options...
StrangerDanger Posted November 20, 2020 Share Posted November 20, 2020 You want 8.5 full rotation from the point the threads grab. Then time it so that the collapsible stock is indexed correctly. I collapse the stock onto the receiver extension and use the pointy part of the cheek rest to point at the center of the rear sight. I then tighten the jam nut with the open end of the 27mm wrench. Then remove the stock, slip the close end of the 27mm wrench over the end and firmly tighten it while putting counter pressure on the extension with a 19mm wrench on the flats of the extension. Verify that the extension didn’t move with the stock again after tightening. 1 1 Quote Link to comment Share on other sites More sharing options...
Aymon Posted November 25, 2020 Author Share Posted November 25, 2020 Thank you. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.