Jump to content

nova recoil reducer installation

Bunnell Fockler

Recommended Posts

I haven't done it myself, but there are a few that have:






There are bits and pieces in each of those threads. Most of the problems with installation appear to arise out of getting the rubber spacer correctly cut and installed. I believe each of those threads address that issue. Other than that, screw it in!

Link to comment
Share on other sites

Just pull off the pad from your Nova from one end and then up. Remember you need the bracket to screw in and it only goes one way you will see its simple. There are only 2 screws but your going to need a long screw drive to reach inside.


In the bracket towards the end of the stock there is a opening where you put in the recoil reducer. A piece of round rubber like hose that comes with the reducer is needed. Once you have added the reducer cut the rubber hose to fit tightly in the left over play. close the cover and put your pad back on. There you go!!!

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...