Hello everyone

[Av12g]

Hey everyone, I’ve been poking around the forum for a bit but just joined. 

here’s my M4

[ClackClackBAM]

I remember drooling over this photo on Reddit last night... glad to see you made your way to the board!

[xblax619]

12 hours ago, Av12g said:

Hey everyone, I’ve been poking around the forum for a bit but just joined. 

here’s my M4

where did u get the heat shield? what brand?

[Av12g]

4 hours ago, xblax619 said:

where did u get the heat shield? what brand?

its a Mossberg 590 heatshield i modified to fit.

[xblax619]

10 hours ago, Av12g said:

its a Mossberg 590 heatshield i modified to fit.

Ya I thought it looked like a mossberg one. What exactly did u do to modify it to fit? I may consider doing the same. Thanks. 

[Av12g]

On 6/30/2022 at 7:27 AM, xblax619 said:

Ya I thought it looked like a mossberg one. What exactly did u do to modify it to fit? I may consider doing the same. Thanks. 

Really all I did was grind down the two rear tabs so the didn’t interfere with the pistons. Then I just bent them inward slightly to fit more securely. You’ll need to make a new or add an extension on to the piece that braces the shield because the stock one is a lot shorter. Also the shield sits lower than the top line of the hand guards, so you may need to coax them in place. The m80 rail is rubber so it was easier to deform but it still pushes the rubber down on mine which makes pulling the barrel a chore because it’s super snug.

[StreetSweeper56]

Heat shield mod looks good tho, the whole gun looks great, welcome!