Benelli M2 shim installation question

[Sirex]

I have a Benelli M2 tactical, and didn't care for the pistol grip stock, and bought a Comfortech stock to install, but it required Benelli shim kit 60850 which I bought. There are several shim plates and a main plate with an offset hole, marked C SX and Z DX. No instructions with the kit on how to install, an what each differently marked shim is for. Are there any instructions online that I haven't found? I did search, and there were a few threads here with a similar question regarding the SBE2, but the links say PAGE NOT FOUND. Thanks for any insight on how these should be installed. I just have in "on there" right now so I can store it in the safe. 

[remarkable]

Here is a good starting point for the M2 in so much as shim kit install.

Starting closest to the receiver.

C - Drop Shim

DX Cast shim

Both of these should be facing towards the butt end of the gun. Install stock.

The Drop Shim Plate should then be set up CDX letters on top facing the butt of the gun.

 

 

 

[Sirex]

3 hours ago, remarkable said:

Here is a good starting point for the M2 in so much as shim kit install.

Starting closest to the receiver.

C - Drop Shim

DX Cast shim

Both of these should be facing towards the butt end of the gun. Install stock.

The Drop Shim Plate should then be set up CDX letters on top facing the butt of the gun.

 

 

 

I will try that tomorrow morning, thanks.