dochoc

I have the s/nova with 24"barrel.I use the nordic +6 and +7.The +6 is about an inch longer than the barrel,and the +7 is about 4" longer than the barrel.I would expect that the +4 and probably the +5 could be used if you want it shorter than the barrel.I also use the clamp.It is very solid but does slightly pull the extended magazine toward the barrel.This hasnt caused any probs so far with the s/nova.The follower is very smooth in operation,the only problem is the colour.It is anodised/teflon coated in a gold colour that can be mistaken for the end of a cartridge.I would have prefered it in red so you could tell quickly that the magazine is empty.

Hi As mentioned the m4 stock does not fit.I have the s/nova Telescopic and it also fits the M2.I am in the Uk though and the stock was a special order via Italy.

Update With some good light,the sprung detent is obvious.With this depressed the safety slides out easily.Unfortunately the oversized replacement (from a nova) does not fit ,and I had to replace the standard one.Anyone know of a oversized replacement.I have tried the DMW version,and the Benelli nova oversized ??

Hi Hope someone can help.Trying to remove the safety button on a Supernova.Have removed the Trigger assembly and taken out the pin holding the bolt stop .This is the bit that sits over the safety button and engages with it to lock the trigger.With the boltstop and its spring removed the safety is fully exposed and looks like it should just push through.Couldnt get it to come all the way out.It still seems to be retained.In the part diagram there appears to be a sprung stop/detent coming up from underneath and engaging.It looks like this needs to be pushed down to allow the safety to come out but I cannot find/feel this at all.Has anybody done this.I read the thread on the Nova removal but it appears to be different.I will scan in the part diagram,and repost.

HI The Super nova uses the mobilchoke system.Dont know if the nova is the same?

Hi You must remove the pistol grip stock first.There is an overlap from the grip over the back of the trigger mechanism.(BTW not required to remove the comfortec stock before trigger removal)