Vinny88 Posted August 2, 2010 Share Posted August 2, 2010 Hi, this is probably a really simple question, but this is my first shotgun and I'm afraid I'm doing something wrong. I'm trying to follow the manual to disassemble and clean my SuperSport and am stuck when trying to remove the trigger group. It says to use my firing pin to push out the stop plug, but I'm not getting anywhere. I feel like I'm pushing pretty hard; enough so that I'm tempted to get a hammer and start whacking at the plug with a screwdriver. I assume that's a bad idea. Any advice? Thanks! Quote Link to comment Share on other sites More sharing options...
tucker301 Posted August 2, 2010 Share Posted August 2, 2010 I wouldn't use the firing pin. I usually use a brass punch and tap it lightly with a small hammer. Quote Link to comment Share on other sites More sharing options...
twowheelhooligan Posted August 3, 2010 Share Posted August 3, 2010 VINNY, What I am using is a Glock armorer's tool(any 3/32" punch) to begin drifting the pin out. If you're going to use a hammer/mallet(*NOT* necessary, use a rubber one!!!!) I just push down on the pin, maybe a 45-degree angle of the punch tip to the pin, it just seems to work for me, and get the trigger group pin started. Once it's about 1/8" out, then I push the pin straight down, tapping it with my palm is all the preassure I need. The trigger-group pin is *NOT* directional, but usually for consistency I just push all pins OUT L-R and push them IN R-L. That's just a me thing. I hope this helps! 2-wheel Quote Link to comment Share on other sites More sharing options...
agm65ccip Posted August 3, 2010 Share Posted August 3, 2010 I push the pin straight down, tapping it with my palm is all the preassure I need. This, get a good pin punch and after a few times of taking it apart it should get easier. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.