Jump to content

magazine spring s.b.e & m1


Recommended Posts

After unscrewing the cap on the magazine tube you should be able to take a screw driver and carefully, so as not to permanently distort the metal ring, pry the c-ring clamp out of the end of the tube. Do it slowly and wear some protective glasses since you are releasing a spring that is under tension. Once you've thoroughly cleaned it, you should be able to push the c-ring back into place by hand. You can go out and buy a special set of plyers to remove the ring but a flat-head screw driver and a little leverage will get the job done.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...