Jump to content

I just fininshed installing my Carrier Comp 7 rnd. mag tube,


Recommended Posts

follower, and spring and the fit and finish is GREAT! I followed the instructions, which are very detailed, and the install went smoothly. As warned, Benelli did apply an ample amount of the thread locker at the factory. Following the instructions, I used a heat gun and an infrared thermometer to complete the install. My thermometer read 313 degrees when I attempted to unscrew the original tube and it took little to moderate pressure. I had to actually apply a little more pressure to unscrew the tube as it was beginning to cool. I used the hard nylon brush to easily remove the rest of the thread locker and then screwed the new Carrier Comp titanium 7 rnd. tube in to place. I also used a small drop of the blue lock-tite during installation. I am very happy with the product and plan to buy another for my L.E. model 11721 when it arrives.




Scott Jens

Check Six Training LLC


C.H.P.D. (ret.)

Edited by Tackelbarry
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...