93gman Posted September 1, 2014 Share Posted September 1, 2014 i have a sbe2 and i am having a problem with the firing pin not stiking the primer in the shotgun shell at the skeet range. i shoot new shells standard 1 and 1/8 ounce federal 8 shot loads. when i shoot 3 inch turkey loads or 3 1/2 goose loads i don't have the problem. any thoughts? Quote Link to comment Share on other sites More sharing options...
truckcop Posted September 2, 2014 Share Posted September 2, 2014 (edited) Google "Benelli click". Locking head doesn't rotate fully into battery after cycling. More of a problem when using light loads, especially with a gun designed to shoot 3 1/2 inch shells, but it can happen any time. If it's a new gun, keep shooting it. Problem sometimes goes away. Sometimes not. I had one gun that did it regularly and another that never did it. I swapped locking heads between the two and never had another problem with either one. Go figure. Edited September 2, 2014 by truckcop Quote Link to comment Share on other sites More sharing options...
93gman Posted September 3, 2014 Author Share Posted September 3, 2014 thank you very much Quote Link to comment Share on other sites More sharing options...
93gman Posted September 3, 2014 Author Share Posted September 3, 2014 would you think benelli would send a new locking head Quote Link to comment Share on other sites More sharing options...
Bruce80118 Posted September 3, 2014 Share Posted September 3, 2014 Make sure the gun is clean and also disassemble the bolt and clean it good. best oh luck!!! ekb:rolleyes: Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.