Jump to content

M4 Shell Stop


onemorevictim
 Share

Recommended Posts

They there guys....i was re assembling my M4. I was putting my trigger group back in and totally forgot to press my shell stop in.

I didnt put too much pressure on the shell stop. Maybe a Moderate amount...it didnt bend....everything works fine....how tough is the shell stop? Should i replace it? is the pin tough?

 

thanks

Link to comment
Share on other sites

Unless you're the hulk with retard strength, it's probably fine. Load a few rounds in the tube and eject them by pressing on the shell stop just behind where the follower is and see if it functions right. It's normal for it to be difficult to get the shell to release using this method. Press the shell release lever on a few and see if it ejects a shell on to the lifter.

 

 

Inspect your trigger pack's shell release lever for damage.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...