Jump to content

Open sight installation issues


Recommended Posts

Received one of those high demand 81131 open sights packages. Base installation no problem.

Front- issue is what screw holds red blade down. Benelli USA say same as gas cylinder. Sends 4 . Will not thread in when spring loaded red blade is compressed? Screw will have clicks like rear elevation.

Rear pin that holds rear blade and spring for elevation is too fat . It was from an extractor pin. Mine broke off and stuck into base right hole. Simple punch will remove but pin is not heat treated and bent when attempting to be installed. 

Benelli USA does not have parts other than gas cylinder hex screws in stock. Supply chain issues.

Anyone successfully install these open sights?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...