frankgoss Posted November 13, 2021 Share Posted November 13, 2021 Received one of those high demand 81131 open sights packages. Base installation no problem. Front- issue is what screw holds red blade down. Benelli USA say same as gas cylinder. Sends 4 . Will not thread in when spring loaded red blade is compressed? Screw will have clicks like rear elevation. Rear pin that holds rear blade and spring for elevation is too fat . It was from an extractor pin. Mine broke off and stuck into base right hole. Simple punch will remove but pin is not heat treated and bent when attempting to be installed. Benelli USA does not have parts other than gas cylinder hex screws in stock. Supply chain issues. Anyone successfully install these open sights? Quote Link to comment Share on other sites More sharing options...
frankgoss Posted November 13, 2021 Author Share Posted November 13, 2021 retaining pin 1/16 " dia 5/8" long. Anyone know where to get Benelli USA has supply clain issues in Maryland. Quote Link to comment Share on other sites More sharing options...
frankgoss Posted November 13, 2021 Author Share Posted November 13, 2021 Bronwells does not carry 1/16" × 5/8" only 1/2" or 3/4" one two short one two long. Packs of 36 or 48 roll pins $3.99 or $4.99 packs. I need one? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.