Kagami Posted May 23, 2022 Share Posted May 23, 2022 Dear all, I am relatively new to guns and looking for help with a reassembly Issue. I disassembled and cleaned my gun after the first shot. But the position of the magazine limiter after reassembly seems to be shorter than before, uncoated areas are visible after assembly. Is this normal or something went wrong during iassembly? Thanks? Quote Link to comment Share on other sites More sharing options...
Ben elLes Posted May 23, 2022 Share Posted May 23, 2022 Check to make sure the barrel is fully seated against the receiver. That side of the weapon doesn’t tell you very much. You want it snuggled down tight is all. Quote Link to comment Share on other sites More sharing options...
Ben elLes Posted May 23, 2022 Share Posted May 23, 2022 If it’s further out than it was before you’ll see a gap at the receiver. Quote Link to comment Share on other sites More sharing options...
Kagami Posted May 23, 2022 Author Share Posted May 23, 2022 Thanks Ben, but it’s further in than it was. That's weird. Are there any components like spacers between them? Quote Link to comment Share on other sites More sharing options...
Ben elLes Posted May 24, 2022 Share Posted May 24, 2022 You may have not had it seated all the way for your first shot then. No spacers. 2 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.