Jkhan29 Posted September 27, 2022 Share Posted September 27, 2022 Just installed the 2 Piece latch on my Benelli M2. Now the shell gets caught on the lifter and the bolt does not ride forward loading the shell. Did not have this issue before. anyone run into similar issue and have a remedy? Quote Link to comment Share on other sites More sharing options...
NoTycoon Posted September 28, 2022 Share Posted September 28, 2022 J Kenny will help you with problems. He only responds thru Facebook Messenger. Reach out and see for yourself. Quote Link to comment Share on other sites More sharing options...
cas Posted October 4, 2022 Share Posted October 4, 2022 Similar. But shells are not stopping hitting the carrier, but getting back under the carrier. Haven't had time to play with it though as it's been a low priority. Be sure to share any info you learn. I'm 0-2 now with them. 1 Quote Link to comment Share on other sites More sharing options...
NoTycoon Posted October 5, 2022 Share Posted October 5, 2022 To both of your issues, have you opened up the hole in your receiver? The spring on the Kenny bolt release must pass freely through the hole. The factory hole is too small. Quote Link to comment Share on other sites More sharing options...
cas Posted October 5, 2022 Share Posted October 5, 2022 Yes I know it's conveniently located at the end of their installation video, a point at which most potential buyers have already stopped watching, having seen the assembly completed and assuming no modification to their receiver will be necessary. lol Quote Link to comment Share on other sites More sharing options...
NoTycoon Posted October 7, 2022 Share Posted October 7, 2022 On 10/5/2022 at 1:23 AM, cas said: Yes I know it's conveniently located at the end of their installation video, a point at which most potential buyers have already stopped watching, having seen the assembly completed and assuming no modification to their receiver will be necessary. lol I was one of them. Reached out to Kenny and that was his first question. Quote Link to comment Share on other sites More sharing options...
cas Posted October 7, 2022 Share Posted October 7, 2022 (edited) The gun I have it on is drastically ground on away, so opening the hole a bit more is of little concern to me. (other than having an oversized hole left over if/when this part takes a dump). But the fact that it will probably need to be done, and isn't stated front and center right away is kind of shitty. Edited October 7, 2022 by cas Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.