tank Posted March 26, 2005 Share Posted March 26, 2005 How do I get # 8 out ? I've tried penetrating oil , heat, heat then dip it penetrating oil to cool, rounded off the 17mm bolt, and if I tighten vise grips any more I'll smash it. I didn't have this problem with my M1 Quote Link to comment Share on other sites More sharing options...
Resident Posted March 26, 2005 Share Posted March 26, 2005 Honestly, I have never disassembled it by myself, but I think that it is not nesessary to get this tube out for cleaning. ### 9 and 10 will come out after removing screwnut #7. Actually, don't listen to me and call them. They will give you detail instructions in no time. Quote Link to comment Share on other sites More sharing options...
tank Posted March 26, 2005 Author Share Posted March 26, 2005 Thanks Resident, and you are right. I screwed up and that's what I meant to say. If I apply any more pressure to hold #8 I'll smash the recoil spring housing, then I'll really have a mess. tank Quote Link to comment Share on other sites More sharing options...
Drundel Posted March 28, 2005 Share Posted March 28, 2005 Its not easy. Put receiver in padded vice. Get a few cheap shop towels and wrap them TIGHT around the tube, and then cover in duct tape, pretty good roll. Then get pipe wrench and only after heating the part where it screws into the receiver for a good bit, try to unscrew. I did it on mine, and it took time but I got it off. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.