Jump to content

Re-assembling Bolt for SBE II


Recommended Posts

This evening I did a detail strip of the bolt of my newly purchased SBE II and cleaned it per the directions provided before heading out to the range this weekend.


I have re-assembled it but want to be certain I did it correctly to that end I took some photos I was hoping folks more familiar with Benelli's on this forum could take a look at to confirm.


I don't have a sufficient post count to put links to photos but if you want to email me through the forum I can send you the link to the pictures.



After re-assembling the bolt when I pressed the bolt face back towards the bolt carrier and then pushed the firing pin with a soft tipped screw driver the pin came out about 1/4 of an inch (just eyeballing it...didn't actually measure).


If you don't mind taking a look it would be greatly appreciated. The gun went back together fine and a test fire with a snap cap felt the same as it did other times.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...