Re-assembling Bolt for SBE II

[Devlin]

This evening I did a detail strip of the bolt of my newly purchased SBE II and cleaned it per the directions provided before heading out to the range this weekend.

 

I have re-assembled it but want to be certain I did it correctly to that end I took some photos I was hoping folks more familiar with Benelli's on this forum could take a look at to confirm.

 

I don't have a sufficient post count to put links to photos but if you want to email me through the forum I can send you the link to the pictures.

 

 

After re-assembling the bolt when I pressed the bolt face back towards the bolt carrier and then pushed the firing pin with a soft tipped screw driver the pin came out about 1/4 of an inch (just eyeballing it...didn't actually measure).

 

If you don't mind taking a look it would be greatly appreciated. The gun went back together fine and a test fire with a snap cap felt the same as it did other times.

[tucker301]

Click Here

The pictures in the guide should be all you need.

If not, send me a PM and I'll give you an e-mail address to send yours to.

[Devlin]

PM headed your way...many thanks

[tucker301]

PM received and reply sent.

Looks good.