Devlin Posted August 18, 2007 Share Posted August 18, 2007 This evening I did a detail strip of the bolt of my newly purchased SBE II and cleaned it per the directions provided before heading out to the range this weekend. I have re-assembled it but want to be certain I did it correctly to that end I took some photos I was hoping folks more familiar with Benelli's on this forum could take a look at to confirm. I don't have a sufficient post count to put links to photos but if you want to email me through the forum I can send you the link to the pictures. After re-assembling the bolt when I pressed the bolt face back towards the bolt carrier and then pushed the firing pin with a soft tipped screw driver the pin came out about 1/4 of an inch (just eyeballing it...didn't actually measure). If you don't mind taking a look it would be greatly appreciated. The gun went back together fine and a test fire with a snap cap felt the same as it did other times. Quote Link to comment Share on other sites More sharing options...
tucker301 Posted August 18, 2007 Share Posted August 18, 2007 Click Here The pictures in the guide should be all you need. If not, send me a PM and I'll give you an e-mail address to send yours to. Quote Link to comment Share on other sites More sharing options...
Devlin Posted August 18, 2007 Author Share Posted August 18, 2007 PM headed your way...many thanks Quote Link to comment Share on other sites More sharing options...
tucker301 Posted August 18, 2007 Share Posted August 18, 2007 PM received and reply sent. Looks good. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.