spiros Posted October 19, 2015 Posted October 19, 2015 hello I was shooting skeet today and the whole recoil pad assembly fell off, any idea what type of glue is used to bond the plastic assembly. thanks spiro Quote
Benelligunny Posted November 11, 2015 Posted November 11, 2015 Super glue! I would suggest taking the pad off the cage first though. Rough up the inside with a little sandpaper and the outside of the cage. Test fit it first. Use a fresh bottle of the gel or thicker kind if you can get it so it doesn't run so bad. Run a bead in the stock where the cage seats and on the sides and put a little on the outside of the cage. Find a work table or wall inside an outbuilding, not the kitchen table, push the cage in, press and hold it against a hard surface for a minute and you're done. Wipe off any excess that might squeeze out quickly. Let it cure and fume for at least a few hours before putting the recoil pad back on. Quote
Benelligunny Posted November 13, 2015 Posted November 13, 2015 Yup, Gorilla glue would probably work just as good. But in any case I would let it cure before putting the pad back on because I know that Gorilla glue. If it over runs to the pad it might become a permanent attachment. Quote
spiros Posted November 30, 2015 Author Posted November 30, 2015 benelli sent me a new piece scuffed it and applied plastic weld. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.