QD mount for Benelli Supernova Collapsible Stock?

[Michael Singer]

Hi, 

Is there a QD mount for the Benelli 61171 Supernova Collapsible Stock?

Thanks,

Mike

 

[M2_shootr]

I’ve considered adding one, haven’t gotten that far.

The polymer has an indent for one, would just need to fit a socket into the stock body

[M2_shootr]

The MagPul socket fits. Will need to open up the molded dimple in the stock body.

 

 

[M2_shootr]

https://www.primaryarms.com/magpul-sling-mount-kit-type-2-mag332

[MrFootball]

On 5/3/2021 at 7:39 AM, M2_shootr said:

The MagPul socket fits. Will need to open up the molded dimple in the stock body.

 

 

Looks great @M2_shootr! I'm looking to do this with my Supernova collapsible stock. I've got the Magpul QD socket. For the Benelli stock, It looks like you have either drill it out or Dremel it? Any helpful tips? How did you do it?

[M2_shootr]

@MrFootball

 

sorry, I just now saw this. Are used to Forstner bit in a drill press. The stock body was supported by an epoxy to sit nicely in the vise.

Once it was poured out, I switch to the other side and did the same. And then you some JB Weld and filled the cavity. The cups were then pressed into position 

 

Edited September 19, 2023 by M2_shootr

[nyc71]

I put a Noveske on mine

https://noveske.com/products/flush-qd-sling-mount/

[M2_shootr]

On 9/19/2023 at 3:56 PM, M2_shootr said:

@MrFootball

 

sorry, I just now saw this. Are used to Forstner bit in a drill press. The stock body was supported by an epoxy to sit nicely in the vise.

Once it was poured out, I switch to the other side and did the same. And then you some JB Weld and filled the cavity. The cups were then pressed into position 

 

Damnit……typos 

stock body was supported by an epoxy bed. I made to support it in the device while drilling.

Once the left side was drilled out, I flipped the stock and repositioned to drill the other side. 
 

and then use some JB weld to fill in the cavity and to seat the QD cups

 

[CEBEP]

On 9/22/2023 at 9:17 AM, nyc71 said:

I put a Noveske on mine

https://noveske.com/products/flush-qd-sling-mount/

Are you still happy with this setup?

[nyc71]

7 hours ago, CEBEP said:

Are you still happy with this setup?

I am but im replacing it with a field stock that I'm having shorten. I don't like pistol grips on shotguns.

[CEBEP]

42 minutes ago, nyc71 said:

I am but im replacing it with a field stock that I'm having shorten. I don't like pistol grips on shotguns.

Thanks. And location is good? I assume it should be on the upper side of the stock on opposite side for correct usage? I don’t have much experience with shot guns. 

[nyc71]

2 hours ago, CEBEP said:

Thanks. And location is good? I assume it should be on the upper side of the stock on opposite side for correct usage? I don’t have much experience with shot guns. 

Correct.