"C" stock sling swivel

[alpha 33]

Could someone kindly direct me to a place where I may find a sling swivel attachment for the "C" stock, that would use the existing hole like in the picture below. Or recommendations ? Thanks

[benelliwerkes]

I was minding my own business this morning and wondered myself how to make it a clean installation.

I prefer the sling mount at the grip level as it balances better for me when used.

I would keep it simple / inexpensive by just using asymmetric Magpul flush cups, both threaded. It does not permanently mar / modifiy the hole. Consider using a thin nylon washer on either side between stock finish and the cup surface.

 

Edited August 29, 2021 by benelliwerkes

[alpha 33]

That is precisely what I'm in search of.   Thank-you very much.

[benelliwerkes]

It occurred to me that it would be a more refined installation without any regrets by employing a bushing (either nylon / aluminum) to eliminate any possibility of QD movement and thus should be included in the task.  I chose aluminum.  This would eliminate need for any thin nylon washers suggested the first time around and because the bushing is proud a few thousandths on each side, it will be the bearing surface for the backside of the QD cups. The bushing was gently tapped right in place, use a nylon head hammer to avoid marring your gun art.

 

Final appearance looks like something the factory would envy functionally and aesthetically.

 

 

Edited August 29, 2021 by benelliwerkes

[Doge]

Made a few of these in free rotation and limited; feel free to use the idea: