Got my rx arms heat shield.Time to make a sbs version

[rubicon20032003]

Since they dont make a sbs version.Think im going to chop and tig and get it refinished.Did mount on my long barrel.To see whet i thought.Very solid and that cap detent system is 100 times better then benelli design 

[mr2jeff]

I am definitely down for a sbs version

[RxArms]

I might add the SBS 13", I'll call it, to the website and get a waitlist going to guage interest.  Big issue I have is I don't have an SBS.  But I am assuming I can just remove 4.5" from my design, and it should work.. Going blind into an expensive prototype is not something I like to do but this would be the only way I could accomplish it.  I have been getting a lot of inquiries about it though.
 

ideally, I need an older M4 (2013 or older barrel) SBS, and then a newer one to test it on, I'd have to enlist community help.  Would only be guaranteed on Benelli OEM barrels,  not any aftermarket chop jobs due to the tolerances required.

the cap design took me a solid 2 months to think of.  Prior to that, I had a wave washer to secure the gun down, but I was never happy with it, and decided to not release it until I came up with a solution.

Edited December 18, 2024 by RxArms

[mr2jeff]

1 hour ago, RxArms said:

I might add the SBS 13", I'll call it, to the website and get a waitlist going to guage interest.  Big issue I have is I don't have an SBS.  But I am assuming I can just remove 4.5" from my design, and it should work.. Going blind into an expensive prototype is not something I like to do but this would be the only way I could accomplish it.  I have been getting a lot of inquiries about it though.
 

ideally, I need an older M4 (2013 or older barrel) SBS, and then a newer one to test it on, I'd have to enlist community help.  Would only be guaranteed on Benelli OEM barrels,  not any aftermarket chop jobs due to the tolerances required.

the cap design took me a solid 2 months to think of.  Prior to that, I had a wave washer to secure the gun down, but I was never happy with it, and decided to not release it until I came up with a solution.

appreciate your work, could probably count me for x2