Jump to content

Nova +2 ext.?


ArmChairCommando

Recommended Posts

I initially had this problem as well when I installed my factory extension. What was happening on mine was that when I would tighten down the extension it was pinching a spring coil between the mag tube and extension. Just load a few shells, then loosen off the extension slightly at both threads and you should hear the spring pop free. Tighten everthing up again and now should be able to load your +2.

Link to comment
Share on other sites

I initially had this problem as well when I installed my factory extension. What was happening on mine was that when I would tighten down the extension it was pinching a spring coil between the mag tube and extension. Just load a few shells, then loosen off the extension slightly at both threads and you should hear the spring pop free. Tighten everthing up again and now should be able to load your +2.

Thanks that must be it!!!! :)

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...