Dukdude Posted December 10, 2007 Share Posted December 10, 2007 I was wondering how I can switch my SBE II safety switch from RH operation to LH operation. I have checked the parts and the LH and RH trigger safetys are the same and the 'indents' are symetrical on the trigger guard so I am assuming the saftey can be removed and switched to LH operation (I am shooting my right handed SBEII left handed now, to address a cross eye dominance thing...). Hopefully someone techically minded can explain here... Thanks, Dukdude Quote Link to comment Share on other sites More sharing options...
HOGWILD Posted December 10, 2007 Share Posted December 10, 2007 http://www.benelliusa.com/forum/search.php?searchid=126170&pp=25 find one of tuckers swap post, i am sure there are several on this thread that explains it in great detail! also has a great cleaning tutorial which can be found with a search!! Quote Link to comment Share on other sites More sharing options...
BrthrB Posted December 10, 2007 Share Posted December 10, 2007 Dukdude, the safety can be switched from right to left-handed. It does require more than a simple fieldstripping and should probably be done by either a gunsmith or a Benelli Armourer. There are some very small parts (pins and spring) involved in the process. It should only take a 'smith or an armourer a few minutes to make the change. Quote Link to comment Share on other sites More sharing options...
Dukdude Posted December 10, 2007 Author Share Posted December 10, 2007 Hog, Thanks for the quick reply, this is just what I was looking for! I also downloaded the cleaning tutorial... Again, thanks, Dukdude Quote Link to comment Share on other sites More sharing options...
HOGWILD Posted December 10, 2007 Share Posted December 10, 2007 tucker said he was working on a bolt group tutorial i think and he said he would add it to his cleaning PDF so keep an eye out for it, great info and glad ya found it!!GL:) Quote Link to comment Share on other sites More sharing options...
Matt D Posted December 10, 2007 Share Posted December 10, 2007 Saved this in a Word Document from Tucker in 05. Hope it helps posted 04-01-2005 10:10 PM04-01-2005 10:10 PM ________________________________________ Remove the trigger assembly from the receiver. Drive out the pin (012A). Be careful, the parts under the pin are springloaded and will fly out when the pin is removed. Cup your hand over the hole to catch them. The spring (007A) and detent (008A) should fall right out now. This will free the crossbolt safety (013J) for easy removal. Reverse the safety, reinsert the detent and spring. Depress ths spring below the hole for the pin and reinsert the pin. Test thoroughly before loading! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.