SBEII too short for me

[HonkWilliams]

I've come to the conclusion that the stock of my synthetic SBEII may be too short to fit me right. When I shoot my right hand (I shoot right handed) is a little too close to my face. Can anyone suggest a solution? Does anyone make replacement stocks for Benellis that are longer than factory ones, entended butts or even extended recoil pads for the SBEII? ?

[Guest GunCrazyD]

unfortunatley the factory does not make and parts to lengthen the stock or the LOP - if someone knows an aftermarket solution that would help this guy out please post it...

[Matt D]

Which gel pad is on your gun? 13.5, 14 or 14.375. If it is the 14.375" you might look at Limb Saver or Hi Viz pads to see if they are thicker than factory pads.

[Honkers41]

Benelli does make different lenghts of recoil pads..so you might want to do a search on that...or try Midway USA gun parts...or Numrich gun parts...but they are out there...recoil pads run about 100.00 for a SBE2. Honkers41

[tdaniel377]

I know its a bum way to extend the pull length but you could always try one of the limbsaver slip on pads over your factory pad to see if that helps,then you can get an adjustable length pad from MidwayUSA.

[HOGWILD]

http://www.benelliusa.com/firearms/partsAccessoriesPads.tpl not sure which one it comes with but their are 3 available? and how much short is it? cradle your shotgun on the inside of your elbow joint and measure where your first digit of your index/trigger finger hits face of trigger. This should be a good indication of how much longer it needs to be and any Gunsmith can fix this issue for a small price if the butt pads can't fix it!

[Matt D]

I just found that Brownells was a replacement plate that allows for different recoil pads to adjust the LOP. You might want to check them out?

[Russ F.]

I've come to the conclusion that the stock of my synthetic SBEII may be too short to fit me right. When I shoot my right hand (I shoot right handed) is a little too close to my face. Can anyone suggest a solution? Does anyone make replacement stocks for Benellis that are longer than factory ones, entended butts or even extended recoil pads for the SBEII? ?

 

I just had to add an 1-1/2" to my stock. I'm 6'9'' and it made all difference in the world. I made it in my CNC machine shop.

 

Russ F.