davidcjones Posted May 15, 2009 Share Posted May 15, 2009 I am new to Benelli firearms. I have a SuperNova with the standard comfortech grip. I ordered a steady grip stock through my gun shop, and it came this week. It should seem pretty basic to swap these, but there are no instructions. I assumed I would remove the nuts from the Comfortech and just pop the new one on. However, the Steadygrip came with a square plate—that I suspect slides through the slot in the stock as part of the assembly and is the stock locking plate for this particular stock. There is also a small rubber piece that I am not sure where it goes. Can someone tell me? I am inclined to simply put the stock on the gun with the square piece that looks like a buckle (stock locking plate) slid into position through the side of the stock and then over the bolt. I will save the elliptical flat stock locking plate that came out of the comfortech but use the same locking washer and nut. I am mainly trying to figure out where this triangular rubber piece goes in the assembly. You'd think a easy one page instruction sheet would come when the parts look different than the OEM stock. Thanks for any guidance. Best regards, David Quote Link to comment Share on other sites More sharing options...
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.